Description
Finally a kit with all-new-parts for your long slip Toyota front driveshaft! These driveshaft builder kits include a long spline kit, weld yoke, flange yoke, and both u-joints. All you need to do is take these components to your local driveline shop and give them your measurements. Choose from our standard duty 8" spline kit, or our heavy duty 10" spline kit. These kits use the most common pattern for 1984-1995 Toyota 4wd trucks and 4runners, which is 60mm x 60mm and uses 10mm driveshaft bolts. You may need to re-drill your transfer case front output flange, or if you are running an common gear drive RF1A transfer case, you can purchase a new triple drilled flange. These 84-95 Toyota single u-joint ends operate at the highest angle of any Toyota driveshaft end at around 42* before bind. Does not include any tubing. Tubing will need to be supplied by your local driveline shop.
Driveshaft Builder Kits Include:
4 Bolt yoke end (60mm x 60mm)
Long spline kit (standard 8" or heavy duty 10")
Two Matsuba Ujoints
You need to supply:
Tubing
Welding
Balancing